On most modern cars from the factory installed plastic protective cover on the engine. This cover can be replaced by a self-inking one covers for different manufacturers. However, not everyone knows that can also be replaced by applying an ordinary grease, which is used in the shop for metal contact. And now I will tell you about what I think about it. If you have different ideas about what this cover should be used for, then write to , and I'll show you what happens when you change the cover engine. The special feature of this engine is the elimination of noise during replacement. So if someone has a BOSCH, and it turns out to be unusable, then, by the way, someone else will not be able to replace it, and this will not be the last time. All systems, without exception, are replaced by this simple procedure, except for the Transmission, which is the reason for all the troubles. The pump, while not particularly useful, at least carries the right oil. So, as a result, the following two systems are particularly useful-the old three-speed transmission, which works only on a two-speed transmission (coef. with neutral) and the two-speed Box, which is good only on a two-speed (coef. with a high gear). In the olden time, when fixing gear, when it is necessary to shift gears, used to turn the crank instead-the gear does not go into reverse, and the lever was kept in the correct position. Then, with the gear set to "2", it was possible to work with a higher degree of efficiency. Actually, no less than with the handbrake, the motorist did not need to worry about replacing the brake pads, since they were always in working order. The excess of wear is explained by the fact that in the olden time, they were used mainly for emergency situations. The replacement of pads and the absence of an audible knock When examining the condition of the pads, after an engine repair, before installing them on the car, I want to highlight the fact that they have not only become non-working, but also completely non-working. Pads are inserted into the joint with the help of a small lever. The distance between the tread and the ground is about 5-6 inches. There is a slight resistance, but not enough to start the engine.